What is Gr5 Titanium ?

- Nov 24, 2020-

Introduction Gr5 materials

Linear expansion coefficient =8.6 * 10-6℃ (0-100℃), specific heat =0.612j/g·℃.The elastic modulus of titanium alloy is low.The elastic modulus E of Gr5 =110GPa, which is about 1/2 of steel, so it is easy to produce deformation in the processing of titanium alloy.Its Poisson's ratio is 0.34.The surface modification of Gr5 (TI-6al-4V) and Gr6 (Ti-5al-2.5SN) titanium alloy was carried out by two injection schemes.

The test results showed that the micro-hardness of titanium alloy was improved after ion implantation, the sliding friction coefficient was significantly reduced, and the wear resistance was effectively improved.X-ray photoelectron spectroscopy (XPS) analysis was performed on the injected and uninjected samples to investigate the modification mechanism, and satisfactory results were obtained.

Gr5 Titanium rod hardness is generally between HRC:31-36,

higher than pure titanium hardness, wear resistance

After ion implantation, the microhardness of the specimens was improved to different degrees, among which the hardness of Gr5 titanium alloy was increased by 1.4 times after injection of (N+ +N+2) mixed beam.

●Gr5 thermal expansion coefficient:

Gr5 titanium alloy has a series of advantages, such as excellent corrosion resistance, small density, high specific strength, good toughness and weldability, etc. It has been successfully applied in aerospace, petrochemical, shipbuilding, automobile, medicine and other departments.

● Mechanical properties of Gr5 Titanium alloy:

Sigma b / 895 MPa or greater tensile strength, of specified residual elongation stress in the sigma r0.2 / MPa or greater 825, 5 (%) of 10 or higher elongation delta, reduction of area bits (%) of 25 or higher.

●Gr5 Titanium alloy density:

Working temperature of Gr5 titanium rod 4.5 (g/cm3) Working temperature -100 ~ 550 (℃)

● Chemical composition of TC4 titanium alloy:

Gr5 contains titanium (Ti) allowance,

Iron (Fe)≤0.30,

Carbon (C)≤0.10

Nitrogen (N)≤0.05

Hydrogen (H)≤0.015

Oxygen (O)≤0.20

Aluminum (Al)5.5 ~ 6.8

Vanadium (V)3.5 ~ 4.5

Gr5 titanium rods are widely used as precision parts in mechanical manufacturing, electric power, electronics, ship, automobile and other fields because of their good physical properties and lower prices than many other titanium alloys.Gr5 titanium alloy is the most widely used titanium alloy.


GR5 Titanium rod


Sale@xastgs.com